Add Speed Position: It can be set up via Hot Key. ● Speed limit alert: Set up the speeding reminder. Abee V51 will send out a ● warning sound immediately when the speed exceeds the set value.
Page 5
Automatically Record: When the car started, Abee V51 will start to record ● automatically; when the car turned off, Abee V51 will save the file and shutdown automatically. Delay shutdown time: When turn off the engine or disconnect to power ●...
In this condition, the time setting can’t be changed manually. 4. Please use Abee V51 original car charger and accessories. 5. In vehicles where power to the cigarette lighter remains on after the engine has been turned off, please remove the cigarette lighter plug to avoid draining your car battery or other accidents.
Page 7
Manual the LCD screen. This may damage it or cause it to malfunction. 12. In general recording mode, press the record button to enter emergency recording mode, on the upper right corner of the screen will immediately show "!Emergency" message, this means the file is protected. The file will not be deleted from loop recording.
Manual Hardware Installation Guideline Hardware Installation Guideline Installation Insert the latch on top of your product in the socket of the car stand to connect the two. Place your driving recorder in the proper position in your car. Stick the suction plate to your car window;...
Page 10
6. Clean the bracket suction plate before installation. Warning Do not install Abee products over an air bag cover or within the air bag deployment zone. The company assumes no responsibility of liability for injury or death as a result of car crashes and/or air bag deployment.
Manual Operational Guideline Operational Guideline Turn on/ Turn off Turn on: When there is no external power, press ON/OFF key and hold for 1 second to turn on the device. Turn off: When the device is power on, press ON/OFF key and hold for 1 second to turn off the device.
Manual Recording General recording: Under general mode, press key to choose REC, to start recording mode. Auto Recording: In the auto recording mode, the device will turns on and enters the recording mode automatically when the power is connected. Stop Recording: Under recording mode, press key to choose STOP, to stop recording.
Manual press to enter emergency recording mode, it will show the message “emergency file is full” and the oldest emergency file will be overwritten. Take a picture Under general mode, press key to take a picture. After take a picture it will return to general mode. Under general mode, press key to take a picture.
Manual symbol meaning of no signal. The car speed is appeared in the screen upper-left after GPS positioning completed. Speed Limit Alert Speed limit alert: Set a speed limit according to your preference in MENU. A voice alert will appear every time the pre-set speed limit is exceeded. Sound control and Voice alert In general or recording mode, press key for seconds for...
Manual Menu function In general mode, press the key to choose Menu, to enter the menu screen. File play: In the menu screen, choose File play . And use key and key to choose type of Video, Emergency or Picture. After choosing the type of video you will see the video playlist, use key to choose the video, press...
Page 16
Manual video. In the menu screen, select Time Stamp, then select ON or Off. Speed Mark: Choosing speed mark or not during video recording In menu screen, select Speed Mark and set ON or Off. ※ This function should be under GPS positioning completed. Resolution: to adjust the resolution of video In the menu screen, then select Resolution, select 1080P/30fps or 720P/30fps.
Page 17
Manual Motion Detection: the device will start record 5-10 before motion is detected until the motion is stop. In menu screen, select Motion Detection, then select On or Off. Collision Detection: in recording mode, when accident or impact occurs the device will automatically record with emergency record function. The sensitivity of collision can be set.
Page 18
Manual Language: to set up the language for operational interface. In menu screen, select Language, then select Traditional Chinese , Simplified Chinese or ( English ) . File Deleting: to delete the existing file. 上下鍵及 In the menu screen, select File Deleting , use key and key to select the video type, Video , Emergency, or Picture .After select the video type you will see the videos list, use...
Memory card (Micro SD) PC connection instruction 1. With a USB cable connection Abee V51 can be connected to a PC via USB cable. When connected, the PC will detect a removable device. Open Windows Explorer to browse files in the V51 memory card.(You can see Abee V51 shows USB connecting…...
RAM: 1G or above Operating System: Windows XP or above Installation: Execute “Setup.exe” from enclosed CD for installing Abee DVR Player. Afterward the Abee DVR Player can be used. Software interface description: A. Window style and file playback display area: Combination, break up the displayed window and file playback route.
Page 21
Manual D. Direction, speed display area: Show driving direction, speed and located coordinate. E. GPS display area: Show the log tracking of video section. (The log tracking will be showed by dotted line without GPS signal such as in tunnel.) F.
Need help?
Do you have a question about the V51 and is the answer not in the manual?
Questions and answers