Nailer Operation; Methods Of Operation - Hitachi nr 65ak2 Instruction And Safety Manual

Removing the nails:
1 Depress the feeder plate knob slightly and slowly
slide the nail feeder forward.
2 Remove the nails from the Nailer.

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 8).
● Operators and others in work
● NEVER point tool at yourself or others in
work area.
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental fi ring.
● Choice of triggering method is important.
Please read and understand "Methods of
Operation" below.
● Never place your hands or feet closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Use only genuine HITACHI hardened nails for
this NR65AK2.
● Be sure to position and insert the fi rst
nail point through the hole in the metal
connectors.
DANGER
area MUST wear
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
WARNING
● Do not drive nails at an angle of less than
50 degrees, since the nails can ricochet and
hurt yourself or someone else.
● Always point fi rst nail protruded from the
nose away from yourself and others.
● Do not push tool forward when positioning
the fi rst nail in hole.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person;
safety
This tool has a Sequential Trip Mechanism (Single Shot)
for use where precision nail placement.
You must fi rst depress the nail point where you want
to drive a nail and then pull the trigger.
After the nail is driven, completely release the trigger
and lift the tool off the work surface.
This tool is not designed for contact trip operation (bounce
fi re), and not available for contact trip valve units.
And this tool has a push lever (safety) mechanism, this is
a diff erent push lever mechanism from another nailers.
The push lever is positioned on top at non fi ring and on
bottom at fi ring.
This tool is equipped with a lockout feature that prevents
the tool from being activated when there are 5 or less nails
in the magazine.

METHODS OF OPERATION

There is a method of operation to drive nails with this
Nailer.
It is intermittent operation (Trigger fi re) only.
(1) Be sure to position and insert the fi rst nail point
through the hole in the metal connector with fi nger off
the trigger.
Be sure to position the nail with triangle mark ( ) at
noe muzzle.
English
15