CPI ARAGON Service Manual page 67

CRANK DRIVE / CRANKCASE / CRANKSHAFT
Clean the mating surfaces of the
crankcase halves with a suitable solvent.
Insert the guide sleeves and apply a thin
layer of sealing compound to the mating
surface of the left crankcase.
Use Loctite® 518 sealing
compound only!
Heated up the right crankcase
to approx. 120°C and mount
the crankshaft bearing. Use
temperature indicating chalk.
Mount the crankshaft in the crankcase.
Mount the left crankshaft seal.
Grease the shaft seal prior to
mounting.
Pay attention not to chock the
shaft seal.
The sealing lip must not get
damaged!
The shaft
positioned
crankcase edge
Special tool: 000W-10
After the mounting of the crankshaft and
check for free movement, the radial
scrankshaft seals shallbe mounted.
seal shall be
below the
CR-12