Setting The Water Hardness - Miele DG 4080 Operating And Installation Instructions

Setting the water hardness

The steam oven is set at the factory for
very hard water (Setting IV).
If your water hardness level differs from
this you will need to re-programme the
appliance.
You can use the test strip supplied to
check the water hardness level, or your
local water supplier will be able to
advise you of the water hardness of
your area.
The water hardness is shown as
settings I to IV equivalent to the
German scale 1 to >21 °dH
(0.2 - 3.8 mmol/l).
Setting Display
I Hardness
level 1
II Hardness
level 2
III Hardness
level 3
IV Hardness
level 4
^ Switch on the appliance.
^ Touch one of the sensors to the right
hand side of the arrows until the
"Settings" menu appears.
^ Touch the sensor next to "Settings".
Hardness level
1-7 °dH
(0.2 - 1.3 mmol/l)
8-14 °dH
(1.4 - 2.5 mmol/l)
15-21 °dH
(2.7 - 3.8 mmol/l)
>21 °dH
(above
3.8 mmol/l)
Before using for the first time
^ Touch one of the sensors to the right
hand side of the arrows until the
"Water hardness" option appears.
^ Touch the sensor next to "Water
hardness".
^ Touch one of the sensors to the right
hand side of the arrows until the
water hardness level you want
appears.
^ Touch the sensor next to the water
hardness level you want.
^ Touch the sensor next to "OK".
Touch the "+C" sensor to return to the
main menu.
17