Daikin FDXS25CVMB Instruction Manual page 6

(3)Attach sealing pad as shown in the figure below. (Stored in outlet vent)
(In order to take in the air inside the ceiling, and when not taking in air from outdoor air, it is not necessary to stick.)
• Attach the sealing pad (accessory) to
the plate metal sections which are not
covered by anti-sweat material.
• Make sure there are no gaps between
the different pieces of sealing pad.
(4)Attach the hanger (right) insulation to the right hanger. (Stored in outlet vent)
(See the below figure for the sticking base line.)
(5)Attach the air filter (accessory) in the manner shown in the diagram.
(5)
In case of bottom side
■ When two indoor units are installed in one room, one of the two wireless remote controllers can be easily
set for another addresses.
PCB in the indoor unit
• Cut the jumper
JA on PCB.
ADDRESS: JA
JA
EXIST 1
JB
ADDRESS
CUT
2
JC
■English
Sealing pad (Small)
(3)
(accessory)
Air inlet
Air
Sealing pad (Large)
discharge
(accessory)
Anti-sweat material
included with the product
For rear intake type
Hanger bracket (right)
Hanger (right) insulation
Slit
Main unit
Attach the
Force filter to the
main unit
while
pushing
Filter
down on
Force
the tabs.
Wireless remote controller
• Cut the jumper J4.
1 2 3
Sealing pad (Small)
(accessory)
Air inlet
Air
discharge
Anti-sweat material
included with the product
For bottom intake type
ARROW VIEW
In case of back side
Wireless
remote
controller
J4 ADDRESS
EXIST 1
CUT 2
Sealing pad
(Large)
(accessory)
J4
4