Salt Indicator - Miele G 848 Operating Instructions Manual

Before using for the first time

Salt indicator

When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with reactiva-
tion salt.
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
started. The "Softener" indicator will
light during this process.
Note:
If your water is soft (below 8 gr/gal) the
salt reservoir should not be filled with
salt. The indicator will remain lit and
should be disregarded or deactivated.
The "Salt-PC" indicator has also been
designed so that future program up-
dates can be entered into the dish-
washer. See the "After Sales Service".
18
Bypassing the Salt indicator
To bypass the salt indicator, you will
need a screwdriver and needle nose
pliers.
^ Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
b
right hand side
^ Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
^ Using needle nose pliers, pull off the
c
cap from the float chamber and
remove the float
^ Replace the float chamber cap, push
the chamber back into its upright po-
sition, and replace the salt reservoir
cap. The indicator should now re-
main off.
.
d
.