Loading Tape Supply - LabelTac 6 Reference Manual

Loading tape supply

1
Lift printer cover open. Remove the green media retainer
from the media supply spindle.
2
Place a roll of supply on the spindle.
retainer so that it sits snug against the loaded supply.
3
Push print head release lever to open print head mechanism.
4 Route the supply over the silver media guide bar, under the
spring loaded damper, between the green media alignment
guides and then out through the mouth of the printer.
5
Press down to unlock and move the sliding alignment guide
until it meets the edge of the supply.
6
Close print head mechanism by pressing down on both
sides, making sure the latches are engaged properly. Close
the printer cover.
14 Using LabelTac Loading tape supply
®
Replace the media
(a)
(d)
(b)
(c)