Polygroup SFS600 Instruction Manual
  1. Manuals
  2. Brands
  3. Polygroup Manuals
  4. Swimming Pool Filter
  5. SFS600
  6. Instruction manual
Polygroup SFS600 Instruction Manual

Polygroup SFS600 Instruction Manual

Hide thumbs Also See for SFS600:

Advertisement

Table of Contents

See also: Owner's Manual
DISTRIBUTED BY: POLYGROUP LIMITED (MCO)
Avenida Xian Xing Hai, Edificio Zhu Kuan, 11 Andar M, Macau
Customer Service Representative: General Foam Plastics Corporation
SFS TYPE SWIMMING POOL FILTER SYSTEM OWNER'S MANUAL
FOR ABOVE GROUND QUICK SET
2X
2X
UL I
S
MPORTANT
AFETY
P
S
RELIMINARY
TEPS
P
F
____________________2
OWER
ILTER
F
C
ILTER
ARTRIDGE
P
M
OOL
AINTENANCE
P
W
C
OOL
ATER
ARE
T
S
ROUBLE
HOOTING
D
A
ISASSEMBLY
ND
P
& A
ARTS
CCESSORIES
N
________________________10
OTES
ATTENTION CUSTOMER: STATEMENT OF LIMITED WARRANTY
Polygroup Limited (MCO) warrants to the original purchaser only, the SFS Type Power Filter against defects in ma-
terial and workmanship, as follows:
1) Polygroup Limited (MCO) warrants to the original purchaser, the SFS Type Power Filter against defects in ma-
terial and workmanship for 180-days from the date of purchase. Original Purchaser must retain proof of such
purchase in the form of a store sales receipt and must produce such upon request by Polygroup Limited (MCO)
or its customer service representative, General Foam Plastics Corporation at (800) 813-0206.
2) You should first consult the Trouble Shooting guide for a simple solution, page #8. If still unable to correct the
situation, please contact customer service representative General Foam Plastic's customer service at
(800) 813-0206. Do not return your pool or parts to the place of purchase. A knowledgeable customer service
representative will assist you in resolving the problem and arrange replacement of defective parts, if needed.
If the unit is found to have been consumer damaged or abused, it is not covered by the limited warranty. If this is
the case, you will be advised of the cost of replacement part(s), or the need to return damaged part(s) for warranty
replacement.
(800) 813-0206 • www.POLYGROUP.com
I
___2
NSTRUCTIONS
________________2
C
_________5
LEANING
________________6
________________7
G
___________8
UIDE
S
_________8
TORAGE
_____________9
SWIMMING POOLS
®
12X
2X
F1000C / F1500C / F2000C
PATENT
PENDING
FILTER
SYSTEM
F600C & F700C
NO GFCI - 2011
084-120814

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SFS600 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Polygroup SFS600

Summary of Contents for Polygroup SFS600

  • Page 1 180-days from the date of purchase. Original Purchaser must retain proof of such purchase in the form of a store sales receipt and must produce such upon request by Polygroup Limited (MCO) or its customer service representative, General Foam Plastics Corporation at (800) 813-0206.

  • Page 2: Preliminary Steps

    (file #E307476) - double insulated and grounded - 115 V.A.C. - 60 Hz. (Unit must have a minimum of 105 V.A.C. to start and run properly.) The units’ wattage and capacity is as follows: SFS600 Filter System with F600C Pump 46 watts 0.8 amps...
  • Page 3 THE FILTER CARTRIDGE (9) WILL HOLD 1” DIAMETER CHLORINE TABLETS. CHECK YOUR CHLORINE LEVELS TO DETERMINE THE PROPER NUMBER OF TABLETS TO ADD. YOU MUST HAVE THIS TYPE OF FILTER WITH A CENTRAL CORE MESH DIVIDER TO USE THE CHLORINE DISPENSER.
  • Page 4 1. POWER FILTER INSTALLATION: (REFERENCE PAGE 3, FIG. 1) WARNING EXTREMELY IMPORTANT! • Risk of electrical shock, connect only to a grounding type receptacle protected by a ground fault circuit interrupter, (GFCI). Contact a qualified electrician if you cannot verify that the receptacle is protected by a GFCI. •...

  • Page 5: Pump Operation

    2. PUMP OPERATION: IMPORTANT: FILTER CARTRIDGE MUST BE FIRMLY SEATED OVER THE PUMP INTAKE PORT TO FILTER THE POOL WATER EFFICIENTLY. NOTE: ONLY FILTER CARTRIDGES WITH A 1-3/4” INCH DIAMETER HOLE WILL WORK PROPERLY. ANY OTHER SIZE HOLE WILL PREVENT PROPER FILTRATION. THE CARTRIDGE MUST SEAL TIGHTLY AROUND BOTH ENDS.

  • Page 6: Pool Maintenance

    POOL MAINTENANCE USING THE DIVERTER FITTING AND VACUUM ADAPTER 1. DIVERTER FITTING USE; diverts direction of return water entering the pool, see part #20 FIG.5. You can adjust the fitting by loosening the LOCKING RING see part # 21 FIG 5. The DIVERTER FITTING can be used to help generate clockwise rotation of the pools water toward the SKIMMER intake opening area of your pools wall.

  • Page 7: Pool Water Care

    POOL MAINTENANCE: 1. Check and adjust pH and chlorine levels daily using required chemicals. See “POOL WATER CARE”, below. 2. Check filter output daily. If flow is reduced, see Symptom 2 in “TROUBLE SHOOTING GUIDE”, page #8. 3. Check filter for leaks. If a leak is found, see Symptom 4 in “TROUBLE SHOOTING GUIDE”, page 8. 4.

  • Page 8: Troubleshooting Guide

    TROUBLE SHOOTING GUIDE DISCONNECT ELECTRICAL CORD BEFORE TROUBLESHOOTING FILTER SYMPTOM PROBLEM POSSIBLE SOLUTION 1 Motor fails to start or A Unit Not Plugged In A Unit must be plugged into a 3-wire grounded outlet with a GFCI type circuit breaker. kicks on and off.
  • Page 10 NOTES Should you encounter any problems, contact the Customer Service Representative/Parts Department at (800) 813-0206 from 8 AM to 5 PM Mon. thru Fri. EST. Extended operating days and hours during peak season requirements.

This manual is also suitable for:

Sfs2000Sfs1000

Table of Contents