Table of Contents
Advertisement
Plasma TVs: 32" and larger This is the most common type of Flat-Panel TV. These TVs are available
in sizes as small as 32" and go all the way past 100". Most have a variety of mounting options. DLP
Wall-Mountable TVs This is the least common type of Wall-Mountable TV. There are usually special
requirements for this mount.
Needed Tools. Some tools used in the installation profession can cost hundreds of dollars. However,
these tools can save hours of work on a project and allow a skilled installer to learn about a house's
construction without cutting into the wall. They also eliminate much of the risk involved in working near
electrical and plumbing systems. Here is a list of tools needed for TV mounting:
? Stud finder
? Tape measure
? Level
? Pencil
? Power drill
? Socket wrench
? Allen wrench
? Wall probe — piano wire, etc
? Wire running tools —
Running Wires You'll need to get a wire from your TV to your equipment. There are a few guidelines
you need to be aware of when it comes to running wires: The National Electrical Code (NEC) is a set of
rules that govern how wires and varying types of power are run in a building. These rules cover both
high voltage (outlets, light switches) and low voltage (phone lines, speaker wires, cable lines). Any work
you do MUST be in accordance with the NEC, as well as local ordinances for your city, county and state.
It's good to have a clear understanding of these rules before you begin. A/V wire can be susceptible to
interference from external sources, such as electrical lines. The NEC dictates minimum safe clearances
for wires, but it is best to keep as much distance between your speaker wires and any potential sources
of interference — you don't want to get all the way through your install only to discover your speakers
"buzz" or "hum" constantly. The wire you use is as important as the equipment itself. The type of copper
and how thick it is, the jacket protecting the copper, the distance it's run — all of these impact how
your system will perform. Make sure you're choosing wire that is the proper material and has a thick
enough gauge for the location and distance it will be run. There are also different wire ratings that
dictate what kind of wires are run in different areas of a house. For example, certain wires are "in-wall"
rated, while others are rated for what is run outside, underground, in HVAC ducts, etc. Since this is
spelled out by the NEC and in any local restriction codes, it is strongly recommended that you make
use of a professional installer if you're unsure of local ordinances.
Wire Running Techniques Beginner Skill Level — 1 or 2 hours, depending on room
Track molding — This concealment option is an adhesive-backed, hollow, plastic trim that
can hold wiring on the inside. When the wires are run inside the trim, the adhesive sticks it into
place against baseboards, in corners, etc. The trim can also be painted, so it blends better with
fish/carpet tape, flex rods, electrical tape
16
Advertisement
Table of Contents
