Table of Contents
Advertisement
the background.
Horizontal channeling — This involves cutting out a path in the wall for the wire to flow
though. Some damage, due to the wall notching or stud drilling, is expected with this technique.
After you run wire though the channel, you will need to patch the hole in the wall.
Intermediate Skill Level — 2 hours, depending on room
Carpet fish — This technique uses a specially designed flat wire to run between the carpet
and the pad. This should usually be routed through low-traffic areas to avoid wear on the wire.
Start by pulling up a section of carpet, usually near where your wire will be run to or from. Then,
feed carpet tape or another suitably long device from the start to the finish of your run and tape
the wire securely.
TECHTIP: When taping wire, make sure to "taper" the wire in a wedge or cone shape
any corners or edges on your tape job can catch and hamper your efforts. This works
best with two people
Intermediate Skill Level — 2 hours, depending on room
Wall fish — This technique uses access from a basement or attic to run wires up or down a wall.
Interior walls are usually empty, but exterior walls will often be blocked with insulation.
TECHTIP: If you have access to a wall where you need a wire fished, drill up from the
lower level or down from an upper level into the center of the wall. Once you have an
access hole drilled, run your wire fish tool, such as a flex rod, down to where you need the wire
run. Tape your wire and feed it through the wall to your desired location.
Attaching the Bracket to the TV/Mount to the Wall Intermediate Skill Level — 3 to 5 hours with little
or no experience
Securing Your TV to the Wall
1. Using a partner, lift the TV and use the upper hooked side of
the bracket to lock onto the lip of the wall mount. See Photo #32.
Before lowering the TV down, make sure that your wires are
ready for connection. If your TV will not allow connections to be
made when it is flat against the wall, take this time to connect
them while your partner holds the TV in place. 3. Once all the
wires are connected or ready to be connected, gently place the
TV flat against the wall, taking care that no wires get caught or
pinched.4. Take this time to double check that the TV is level.
Once this is verified, secure all locking screws or bars.
If you've made it to this point, congratulations on a job well done!
(Note: This information is provided to help guide your installation. Haier assumes no liability for errors
or the outcome of any installation since each project is unique and tools, materials, techniques, local
codes and regulations vary and change.)Preparing for Your Installation In planning your speaker
—
one to feed the wire and one to pull from the other end.
17
—
Advertisement
Table of Contents
