Miele KM 5676 Operating And Installation Instructions page 29

What if one or more residual heat indicators flash?
Possible fault
There was a power failure during use.
The burners are turned off.
The residual heat indicators were lit
while the programming mode, e.g.
Safety Lock, was selected.
What if when the cooktop is turned off, the timer display shows numbers
and the burner displays show A, F or numbers?
The touch controls could not be reset
automatically. They must be reset
manually.
What if the rear burner display shows F, the front burner display shows E
and the timer shows numbers?
Possible fault
Trip the circuit breaker to the cooktop
or disconnect the appliance from the
main power supply for 1 minute.
Frequently asked questions
Fix
Turn the cooktop on as usual.
The residual heat indicators will flash
for about 45 minutes after leaving the
programming mode.
The cooktop can be used as usual.
See, "Resetting the touch controls -
Manual reset".
If the problem persists, call Miele
Technical Service.
Fix
If the problem persists, call Miele
Technical Service.
29