Advertisement
AIRSTREAM CLASSIC TRAILER OWNERS MANUAL
MICROTECH™ FILTER INSTALLATION
NOTE: Faucet will not operate in any mode without filter. Filter should be left in protective bag until ready
for installation, The MicroTech™ filter is a high performance carbon block filter developed specially for
the PureTouch Filtering Faucet System. Once the filter is installed in the pullout spout, it should not be
removed until it is to be replaced. The electronic module keeps track of the amount of filter life
remaining and will signal you when the filter change is necessary. If a partially used filter is removed
and reinstalled, the electronic indicator will automatically reset and will not accurately reflect filter
life remaining.
Use only Microtech filter cartridges with the PureTouch Filtering Faucet System.
1. Remove the filter cover by lifting it up and away from the
pullout spout body.
2. Insert the new filter by aligning the outlet tubes on the filter
with the inlet ports of the spout body and gently pressing in and
down. Upon successful installation of the filter cartridge, the
filter life indicator will beep three times and reset automatically.
(Do not remove the filter until it is to be replaced.)
3. Re-install the filter cover by positioning the alignment tab
with the corresponding notch in the main pullout spout body
and gently pushing in and down.
4. Attach the pullout spout to the hose by aligning the dots on
the quarter turn connector (18) and the spout. Push the quarter
turn connector onto the spout assembly and turn it clockwise,
locking it in place.
5. Allow cold water to run through the new filter for 5 minutes
to flush out any loose carbon particles. Once these small black
particles are washed out the filter is ready for use.
The PureTouch System installation is now complete. Please
read carefully the operation instructions to ensure optimal
performance.
CARE AND MAINTENANCE
All that is needed to clean your faucet is a soft damp cloth. Moen does not recommend the use of scour
pads, cleansers or chemicals. The abrasive nature of these substances could damage the faucet's finish. A
nonabrasive car wax will help to protect the finish. DO NOT PLACE WAND APPLIANCE IN A
DISHWASHER.
F-13
Advertisement
