1. Product introduction Thank you very much for choosing our range hood. Our company has developed a series of range hoods on the basis of assimilating the advantages of high volume of air, lower noise and elegant appearance. Production Configuration 1 Exhaust pipe 4 One-way valve Lamps...
range. Mark the position of the holes, which need to be drilled in order to mount the range hood. 2) According to marks, drill two holes appropriate for heavy duty wall anchors and screws(not included). Mount the range hood on the wall with the two screws and anchors and tighten.
Air pressure >160 Noise level dB(A) <70 Air output diameter 4. Maintenance 1) Make sure to pull out the plug and cut off the power before maintenance to ensure your safety. 2) Clean the inside and outside of the range hood with warm water containing neutral detergent, then dry them with a piece of dry cloth.
as banana oil and gasoline. 5. Cautions 1) Do not attempt to install this appliance yourself without appropriate electrical and technical background. 2) When maintaining this range hood or changing a light bulb, please be sure that all power switches are in the off position. 3)Do not let the detergent flow into the electric appliance box and the switches when cleaning the inside of the range hood to avoid leaking electricity.
Page 7
the hob and the lowest part of the range hood, when the range hood is located above a gas appliance. This distance should be at least 70mm. If the instructions for installation for the gas hob specify a greater distance this has to be taken into account. 13) Regulations concerning the discharge of air have to be fulfilled.
Need help?
Do you have a question about the ED RIGEL 1200 and is the answer not in the manual?
Questions and answers