Network Connections; Connecting The Ethernet Devices - NBase NH 210 Installation And User Manual

NH210.QXD 21/6/99 13:22
NBase Communications
terminated as required by the country where it will be installed.
Le cable de transport d'energie que doit etre utilisé la configuration 230 Volts est le
type minimum SJT (SVT) 18/3, nominal 250 Volts AC, 10 Amps, 4.5m long maximum.
Un bout est raccorde comme exige par le pays ou il sera utilisé.
Das Netzkabel ist das hauptsachliche Diskonnektionsmittel, es sollte in eine leicht erre-
ichbare steckdos gesteckt werden. Das Netzkabel kann mit einer 230 Volts
Konfiguration verwonder werden vom typ: Minimum VDE or HAR, 3 X 1.00 mm2, 250
VAC, 10 Amps, maximal 4.5m long. Ein Ende ontspriche dem Stecker IEC 320. Das
andere Ende entspricht den Anfoderungen des entsprechenden Landes.
Input Supply
Check nameplate ratings to assure there is no overloading of supply circuits
that could have an effect on overcurrent protection and supply wiring.
Grounding
Reliable earthing of this equipment must be maintained. Particular attention
should be given to supply connections when connecting tp power strips, rather
than direct connections to the branch circuit.

Network Connections

The cable connections to the 10Base-T ports can be UTP/STP Category 3/5;
for 100Base-TX ports, only Category 5 cable should be used. Cable length is
limited to 100 meters on each port. STP cable carries a higher quality of signal
and is less sensitive to environmental noise.

Connecting the Ethernet Devices

The 10Base-T and 100Base-TX ports on the NH 210 are designed to be con-
nected directly to a server or PC, using a standard straight through patch cable.
In order to cascade switches or connect a hub to the switch, a crossover cable
must be used.
Page 9
NH 210
9