Attaching The Mounting Surface On The Top Surface Of The Camera Body - Panasonic WV-SW316L Installation Manual

Attaching the mounting surface on the top surface of the camera body

When the mounting surface is changed to the top surface of the camera body
z
Remove the 4 sunshield fixing screws from the camera body and remove the sunshield.
x
Remove the 4 tripod head fixing screws from the camera body and remove the tripod head.
c
Loosen the fixing screw x1 and remove the rear cover, and remove the cap.
v
Rotate each cable in the direction of the arrow (clockwise) as illustrated and pass them between
opening in the upper groove of the main body.
Then, attach the cap to the lower groove, and secure the rear cover with the fixing screw x1.
Rear cover
Attach the rear cover to the front cover by hooking attachment hole 1 of the rear cover to the tab on the
front cover while passing the protrusion of the front cover through attachment hole 2 of the rear cover.
(This illustration represents WV-SW316.)
34
Tripod head fixing screw x4
Fixing screw x1
Tab Protrusion
(This illustration represents WV-SW316.)
Attachment hole 1
Upper groove
Cap
Tripod head
Attachment
hole 2