Panasonic WV-SW316L Installation Manual page 32

w To adjust the angular field of view with a higher zooming effect even after adjusting the angular
field of view almost fully in the "T" direction, hold down the focus assist button (F.A.)/extra opti-
cal zoom button for 5 seconds or more. 2x extra optical zoom will be applied. When the image
capture size under "VGA" is applied, the zoom factor can be adjusted up to 2x without deterio-
ration of image quality. When holding down the focus assist button (F.A.)/extra optical zoom
button again for 5 seconds or more, 1x extra optical zoom will be applied.
e Tighten the zoom lock knob.
r Press the focus assist (F.A.) button.
→
"FOCUS ADJUSTMENT" menu will be displayed.
The focus assist function will be activated to perform the optimum adjustment.
t When the focus lock knob is positioned near the best focus position, the position will automati-
cally be memorized as the "PEAK HOLD" position. (The closer the focus ring is positioned to
the best focus position, the greater the "PEAK HOLD" value becomes.)
y When the focus lock knob is moved, the current focus position will be indicated on
"INDICATOR". Adjust the focus position so that the indicator value goes close to the "PEAK
HOLD" position.
u When the indicator value goes to the best focus position, "BEST FOCUS" will be displayed in
reverse at the lower right corner of the screen.
i Tighten the focus lock knob so as to fix the best focus position.
o Press the focus assist (F.A.) button again to close the "FOCUS ADJUSTMENT" menu.
(No operation for 3 minutes also closes the menu.)
IMPORTANT:
• When using a model equipped with the focus assist (F. A.) function, defocus may be caused by the
dome cover attached.
In this case, the focus adjustment will be easier by detaching the dome cover and moving the
focus ring to the "N" direction.
• Before attaching the dome cover, make sure that the subject is present.
Note:
• I f the zoom lock knob is fully rotated in the "W" direction, the periphery may become dark. In
such a case, rotate the zoom lock knob in the "T" direction for readjustment.
• W hen shooting the following subjects, close the "FOCUS ADJUSTMENT" menu by pressing
the focus assist (F.A.) button again, or adjust the focus to obtain the best focus position while
monitoring images from the camera.
• Place where the front cover easily becomes dirty
• Subj. with large illuminance change
• Subj. with reflection or extra brightness
• Subj. with less contrast such as white wall
• I f the zoom lock knob is slightly tightened before the zoom is adjusted, the ring will become
stable, making fine adjustments easier to perform.
• I f the focus lock knob is slightly tightened before the focus is adjusted, the ring will become
stable, making fine adjustments easier to perform.
• I n case the angular field of view has changed during adjustment, close the "FOCUS
ADJUSTMENT" menu once by pressing the focus assist (F.A.) button. (When the angular field
of view changes, the indicator values of "PEAK HOLD" and "INDICATOR" also change.) After
fixing the angular field of view, retry Step 3.
• If the 2x extra optical zoom is applied when "1280x960", "1280x720" is selected for the image capture
size, the image quality will be deteriorated because the effect of Extra Optical Zoom is not provided.
32
• Subj. moving frequently
• Subj. with low illuminance
• Subj. through a window
• Subj. with heavy flicker