Table of Contents
Advertisement
Insert the Power plug into the POWER input on the rear panel of the TOPVerb and
plug the power adapter into an AC outlet.
Turn on the power of the amplifier/mixer, and adjust the volume.
4.2. Installation
a. Standard Use
The TOPVerb may be placed almost anywhere: on a table, on top of an amp,
next to a mixing console. If it will be on furniture, check the rubber feet provided
to the bottom of the unit. Make sure to place the TOPVerb's power supply away
from other audio equipment that may induce fields, and away from the signal
wiring. It is possible that TOPVerb may pick up noise fields generated by other
equipment such as large power amplifiers; in this case, move the TOPVerb until
the noise goes away.
b. Application Examples
- LINE INSTRUMENT
When connecting audio cables and/or power cord to mains, make sure that all
devices in your system have their volume controls turned down.
The TOPVerb has two 1/4" unbalanced inputs and two 1/4" unbalanced outputs.
These input/output configuration may provide three different audio connections
options:
Connect an audio cable to the [LEFT] INPUT of the TOPVerb from a
MONO.
mono source, and another audio cable from the [LEFT] output of the TOPVerb
to an amplification system or mixer input.
To Amplifier or Mixing Console
A102
9 VAC~
POWER
FOOT SWITCH
MONO IN, STEREO OUT.
two audio cables to the [LEFT] and [RIGHT] outputs of the TOPVerb to a stereo
amplification system or two mixer inputs.
From Instrument or Effects Send
Left Output
OUTPUT
R
L
While still using a mono input, you could connect
8
Left Input
INPUT
(MONO)
R
L
Advertisement
Table of Contents
