Analog Connections (Back Panel); Analog Inputs/Outputs; Power Connector; Installation & Connection - Alto TOPVerb User Manual

3.2 Analog Connections (Back Panel)

A102
9 VAC~
POWER
a. Analog Inputs/Outputs
- Inputs: These are 1/4" unbalanced phone jacks which connect to sources such
as the effects sends of mixing console. They may be used with nominal input
level.
For mono application, use the Left / Mono input. The Left / Mono input jack is
normal to the Right jack. This means that when nothing is plugged into the Right
input jack, the signal present at the Left / Mono input is routed to the Right as
well.
- Outputs: These are 1/4" unbalanced phone jacks which connect to devices
such as the effects returns on a mixing console or power amplifier inputs.
b. Foot switch
- Foot Switch: This is a 1/4" phone jack, which allows connecting a footswitch
for muting the unit. If you want to activate or inactivate the effects, only to
touch the footswtich.
c. Power Connector
- Power connector: This is a plug for connecting the 9VAC power supply adaptor
provided by the manufacturer.
4. Installation & Connection

4.1 Audio Connections and Power Up

a. Audio Connections
The connections between the TOPVerb and the other audio devices have to be
made using high quality cables so to prevent bad performances of the TOPVerb
itself. So it should be good to use low-capacitance shielded cables with a flexible
internal conductor.
b. Power Up Setting
Before turning on the system's power, please use the following procedure, check if:
All connections have been made correctly.
The volume controls of the amplifier or mixer are turned down.
OUTPUT
FOOT SWITCH R
7
INPUT
L R L (MONO)