Advertisement
Operating
Manual
1) Remove the three cap screws (4mm hex) and the one flat head screw (3mm hex) as
shown.
2) Remove the side cover after screws are removed. The side cover is a close fit and may
require a screwdriver to pry off near the tension arm.
3) Examine the mechanical linkages for over-all condition such as dirt, metal filings, liquid
contamination and lubrication.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Maintenance: Tool Body and Linkages
Pry Here
www.BAND-IT-IDEX.com
Page 32 of 36
IT5000-C / IT6000-C
3/8" IT Tool
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
