Advertisement
Operating
Manual
Three
additional
mounting holes are available
to assist with mounting the
tool. Thread size is M5 for all
holes.
One hole is utilized to attach
and lock the tool body cover
to the tool body. This hole
may also be used for a fixture,
provided the M5 cap screw is
replaced with a similar screw
with
appropriate
length.
The center block should allow for the buckle to pass around the work piece
This will allow the tie to be threaded from either end
Clamp guild material should be
heat treated tool steel
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Fixture Mounting Holes
fixture
thread
Fixture guide for Tie-Lok
www.BAND-IT-IDEX.com
Page 22 of 36
IT5000-C / IT6000-C
3/8" IT Tool
®
Ties
Document # P48850 Rev. C
BAND-IT-IDEX, Inc. 2015
All rights reserved
© Copyright
Advertisement
