Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for ALcom AT5933
Summary of Contents for ALcom AT5933
-
Page 2: Safety Instruction
INTRODUCTION Thank you for purchasing our newest Alcom Caller ID phone. This manual is designed to familiarize you with this phone. To get the maximum use from your new phone, we suggest that you read this instruction manual carefully before using. -
Page 3: Location Description
Ringing volume 8 steps for selection LCD backlight Hands free dialing function In use and new LED indicator LOCATION DESCRIPTION... -
Page 4: Getting Started
GETTING STARTED 1. The unit requires 3 X 1.5V AA batteries. Open the battery compartment cover and insert the batteries in the right polarity, then close the cover (Proposal using alkaline battery). There should be time display on the liquid crystal screen after the batteries are inserted. 2. -
Page 5: Reviewing, Calling Back And Deleting Incoming Numbers
2. When you hear the dial tone, dial the desired number. 3. The unit will start to time the conversation after 6 seconds. 4. When finished, return the handset to the base. From H.F. mode 1. Press H.F. key 2. When you hear the dial tone, dial the desired number. 3. -
Page 6: Preventing Fsk Message To Auto-Adjust Real Time
“13”). NEW INCOMING CALL LED AND RINGING LED New and ring indicator is the same LED, when a new call comes in, the LED is blinking, when a new number has not been reviewed, the LED is blinking in 4s interval. PREVENTING FSK MESSAGE TO AUTO-ADJUST REAL TIME When a FSK message comes, the unit adjusts real time automatically, you can prevent real time auto adjustment as follows:... - Page 7 4. Repeat the above steps for the rest code setting. Adjusting LCD Contrast 1. After setting up the local area code, press SET key, LCD display LCD 08 2. Press UP/+ or DOWN/- key to adjust the LCD contrast, total 16 levels can be selected. 3.
-
Page 8: Adjust Handsfree Volume
transfer calls from that different model phone to the model referred in this manual and intercom during may not be possible in certain cases. • If the paging number is set, Anti-steal dialing function will not work. • This feature will work only on regular PSTN networks. •... -
Page 9: Setting Pabx Code
SETTING PABX CODE 1. In on-hook state, press and hold DEL key 3 seconds to set PABX code, LCD displays SET PCODE- and the” -” flashes. 2. Press UP/+ or DOWN/- key to set PABX code from 0 to 9. 3. -
Page 10: Low Battery Detection
be dialed out. LOW BATTERY DETECTION When the voltage is lower than 3.9v, LCD displays “ ” icon to remind the user to replace the batteries. LCD BACKLIGHT FUNCTION The backlight is turned on when receiving an incoming call, dialing, pressing any key or in MUSIC HOLD mode. -
Page 11: Troubleshooting
Note: Due to continuous product development all features and specifications are subject to change without prior notice For more Information on Warranty and Product Support in Singapore please call (65) 68412668 or Fax to (65) 68412628. Email: support@alcom.com.sg Website: www.alcomonline.com...
Need help?
Do you have a question about the AT5933 and is the answer not in the manual?
Questions and answers
my phone answers in german