Advertisement
Careful
planning,
inspection have all contributed
the high standard of quality found in this tool.
are confident that you will find it satisfactory
every respect.
To increase the versatility of this saw beyond the
normal
range
attachments "are readily available.
To prevent damage in shipment some of the parts
were disassembled from the tool.
listed below. Be sure they are all accounted for be-
fore discarding any of the packing material.
I . Fence; item II I .
2.
Miter gage assembly; item I 23.
3.
Motor alignment rod; item 17.
4.
Motor mount complete; item 26.
5.
Insert with clips; items 12, 13, 14 and 15.
6.
Motor pulley; item 64.
7. V-belt; item 62.
ASSEMBLY:
Fence and Miter Gage
Install as shown in Fig. I.
Motor Alignment Rod
The 5/1 6 x 4 1/2 inch motor alignment rod, No. I 7,
fits into the hole in the back of the splitter bracket.
Insert the rod as far as it will go into the bracket
and tighte:n the set screw.
r
OPERATING
INSTRUCTIO~S
8 INCH BENCH SAW
preCISIOn machining,
toward maintaining
of bench
saw operations,
These parts are
AND PARTS LIST FOR
Model 103.22160
-r
FIGURE
and rigid
Motor Mount
Install as shown in Fig. 2 and outlined under "Instal-
We
lation of Saw".
in
Insert with clips
Install in opening provided in table top. See Fig. 4.
various
INSTALLATION OF SAW:
There are four 5/16
the base of the saw through which the tool should
be fastened securely with screws or bolts to a well
built work bench.
the blade will allow sawdust to escape.
The Motor Mount Bracket should be installed as
shown in Fig. 2.
I.
Set the saw at 0 inches elevation and 0 degrees
tilt.
2
diameter
holes provided
A large hole in the bench below
(See paragraph headed "Controls".)
FIGURE 2
in
Advertisement
