1. The Part Number. 2. The Part Name 3.The Model Number 103.23420 which will be found on a plate on the right side of the base. This list is valuable. It will assure your being able to obtain proper parts service.
Page 2
OPERATING INSTRUCTIONS AND PARTS LIST FOR CRAFTSMAN BENCH SAW Model 103.23420 ASSEMBLING LUBRICATION This bench saw was completely inspected and tested at the factory. To prevent Before operating this saw, remove the two oil plugs over the spindle bearings damage during shipment, the fence assembly, the guard and splitter (Figure 2) and fill the reservoirs with a good grade machine oil of S.A.E.
Page 3
CONTROLS The table crank (Figure 2) when turned will raise or lower the table in relation to the saw blade, thus regulating the depth of cut as indicated on the depth of cut scale. The table clamp screw locks the table in position, and therefore should be loose during adjustment of table height.
Page 4
SPEED CARE OF THE SAW BLADE; This bench saw will give best results when operated at approximately 4500 When the blade requires sharpening, before filing the teeth, first make sure R.P.M. Satis. factory operating speed and power can be obtained with a 1/2 that they are all of the proper length.
Page 5
Prepaid Prepaid Selling Selling Part Price Part Price Each Each 33414 Table Tilt Protractor BASE AND RELATED PARTS 33419 Depth of Cut Pointer 38034 Pulley and Set Screws Single Groove--2 in. V-Pulley 33422 Table Tilt Lock Nut 1/2, in. Bore. Purchase from Div. 9 in Sears Retail 33617 Table Crank Shaft Stpre...
Page 6
Prepaid Part No. Selling THE FOLLOWING PARTS ARE STANDARD AND Part Name Price Each MAY BE PURCHASED LOCALLY. 18619 Fence Clamp Knob Prepaid 18624 Fence Guide Bar-Rear Selling 18969 Fence End-Rear Part No. Part Name Price Each 18971 Table Insert 33101 Rip Fence Assembly Complete 4.50...