Saito ProCharger S Operating Instructions Manual page 2

SaitoProCharg erS
The Saito ProChargerS is an automatic plug-in charger for motorcycle,
scooter and quad bike/ATV starter batteries. It is adjustable between 2 V,
6 V and 12 V by means of a sliding switch and suitable for all customary
standard lead-acid batteries – meaning all batteries included in the Louis
assortment. It is furthermore appropriate for charging all maintenance-
free gel, EXIDE, HAWKER and AGM microfleece batteries. According to
the I-U principle, it charges the lead battery with a maximum current of
400 mA (0.4 A) first, until reaching charging end voltage for the
respective battery. This is detected by the charging device which then
switches to constant voltage and adjusts the charging current (trickle
charging function). In this way the battery voltage constantly stays on an
optimal level. Therefore the battery can remain connected to the
charging device for a longer period of time. This device is therefore also
ideally suitable for winter storage. The LED displays of the charging
device provide constant information on the current operating status. The
plug-in charger is secured against overload and short-term short circuit
(< 1 min.). Pay attention to the charging output polarity! A protective
circuit prevents charging in the case of polarity reversal which could
damage the battery and the charging device. Polarity reversal is
signalised by means of a red light. Connection is enabled via coloured
pole clips. Due to a protective circuit, the charging clips do not conduct
any voltage, as long as they are not connected to a battery. Voltage can
thereby not be measured from the open charging clips, either. The Pro-
ChargerS can be optionally connected to the battery with crocodile clips
or ring terminals (=eyelets).
2