Saito ProCharger S Operating Instructions Manual page 10

Dangers
Please contact an authorised service centre, if you have any doubts
concerning the functioning, safety or the connection of the device.
Check the product and its cables for damages before any start-up. Do
not operate the device, if the protective insulation of the power or
charging cable is damaged (squashed, cracked, ripped etc.). If you detect
any damages, do not operate the device, but take it to an authorised
service centre. Even if the device is not functioning anymore, operation
must be stopped immediately and the device must be returned to the
manufacturer for repair.
Do not work with the charging device in rooms or adverse environments
which contain or might contain combustible gases, fumes or powders.
Never cover up airing slots resp. the device. Do not place the device close
to sources of warm air such as heatings or the like! Do not expose the
device to direct sunlight, a lot of dust, mechanical vibrations or impacts.
Do not operate the device close to or on top of combustible or easily
inflammable materials. Use a respective non-combustible base (e.g. a
large, thick porcelain tile or a stone plate). Do not place or lead the
charging cable or the power cable close to inflammable materials.
Do not use the charging device on a boat or a water vehicle. The battery
must be removed from the boat or the water vehicle for charging. It
should be charged at a suitable location.
The charging or power cable may not be modified resp. extended or
shortened. It may neither be bent or squashed, nor led across
sharp-edged parts. Voltage cables or circuits, which the device is
connected to, must always be inspected with respect to insulation
defects, breakage, squashing or bending before and after the use.
10