Datawind 7c+ EDGE Service Manual page 50

.
Step 3: Load the image from Hard disk Location.
Step 4: Power off the Device and disconnect from computer if connected.
Step 5: Put the device into recovery mode by continues pressing volume (-) key and toggle pressing
power key 4-5 times.
Step 6: Keep on pressing volume (-) key and connect the device to computer using data cable.
Step 7: Once the following message arrive, release volume (-) key.
Step 8: Click yes on each message that arrives and the flashing process will start.
50 Datawind Properietry:should not be shared without permission
.
Prepared by- Vikas Kumar