Download  Print this page

Complete Installation Checklist; Door Reversal (Optional); Electric Models - Whirlpool W10573707B Installation Instructions Manual

Hide thumbs

Advertisement

COMPLETE INSTALLATION
CHECKLIST
<
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
<
Check that you have all of your tools.
<
Dispose of/recycle all packaging materials.
<
Be sure the water faucets are on.
<
Check for leaks around "Y" connector, faucet, and hoses.
<
Check dryer's nal location. Be sure vent is not crushed
or kinked.
<
Check that dryer is level. See "Level Dryer."
<
Remove lm on console and any tape remaining on dryer.
<
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
<
Read "Dryer Use" in your Use and Care Guide.
<
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.

Electric Models

<
Plug into a grounded outlet.
Gas Models
<
Plug into a grounded outlet.
<
Check that gas supply is on.
<
Check for leaks.
<
Check to be sure that the exible gas line is not crushed
or kinked.
All Models:
<
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Start button has been pressed rmly.
• Dryer is plugged into an outlet and/or electrical supply is
connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its rst cycle.
NOTE:
You may notice an odor when dryer is rst heated. This
odor is common when heating element is rst used. The odor will
go away.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with a round and
square-shaped doors.
Tools needed:
Min. 8" long TORX
®
††
®
T25
screwdriver
††
Reverse door swing round-shaped door – single handle
IMPORTANT: If the protective lm has not yet been
removed from the dryer, peel the lm from the dryer
door before proceeding.
®
®
Using a TORX
T25
screwdriver, remove the 4 screws
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Reinstall the 4 screws in the holes.
††
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.
#2 Phillips screwdriver
15

Advertisement

loading

  Related Manuals for Whirlpool W10573707B

This manual is also suitable for:

W10573708b-sp