Settings For The Sound (Audio Setup) - Sony DVP-FX870 Operating Instructions Manual

Settings for the Sound
(Audio Setup)
"Audio Setup" allows you to set the sound
according to the playback and connection
conditions.
Select "Audio Setup" in the Setup Display.
To use the display, see "Using the Setup
Display" (page 30).
The default settings are underlined.
Audio Setup
Audio DRC
Digital Output
Select:
◆ Audio DRC (Dynamic Range Control)
(DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "Audio DRC."
This function affects the output from the
following jacks:
– AUDIO jack
– OPTICAL OUT jack only when "Dolby
Digital" is set to "Downmix PCM" (page
32).
Standard
Normally, select this position.
TV Mode Makes low sounds clear even if
you turn the volume down.
Wide Range Gives you the feeling of being
at a live performance.
◆ Digital Output
Selects if audio signals are output via the
OPTICAL OUT jack.
On
Normally select this position.
When you select "On," see
"Setting the digital output signal"
for further settings.
Off The influence of the digital circuit
upon the analog circuit is
minimal.
32
GB
TV Mode
Off
ENTER Cancel: RETURN
Setting the digital output signal
Switches the method of outputting audio
signals when you connect an audio equipment
such as an AV amplifier (receiver) with the
OPTICAL OUT jack.
For connection details, see page 35.
After setting "Digital Output" to "On," select
"Dolby Digital" and "DTS."
If you connect a component that is
incompatible with the selected audio signal, a
loud noise (or no sound) may be heard from
the speakers, damaging your ears or speakers.
◆ Dolby Digital (DVD only)
Selects the type of Dolby Digital signal.
Downmix
Select this when the player is
PCM
connected to an audio
component without a built-in
Dolby Digital decoder.
Dolby Digital Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
◆ MPEG (DVD only)
Selects the type of MPEG audio signal.
PCM
Select this when the player is
connected to an audio
component without a built-in
MPEG decoder. If you play
multi-channel MPEG audio
sound tracks, only the Front (L)
and Front (R) signals will be
output from your two front
speakers.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
◆ DTS
Selects whether or not to output DTS signals.
On
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
Off Select this when the player is
connected to an audio
component without a built-in
DTS decoder.