Simple Setup; Using The Device In A Local Network - Asus WL-330 Quick Start Manual

Simple setup

This section provides instructions on how to use your ASUS Pocket Wireless AP
in various operating modes and conditions.

Using the device in a local network

In a local network, you may use the ASUS Pocket Wireless AP to connect a
WLAN-enabled desktop PC or notebook with or without a DHCP server.
To connect a WLAN-enabled desktop PC or notebook to the ASUS Pocket
Wireless AP:
1. Switch the device to AP mode using the mode switch. (Default SSID:
AP_xxxxxx)
2. Turn on the ASUS Pocket Wireless AP, then connect one end of the
RJ-45 cable to the Ethernet port of the device and the other end to the
Ethernet port of the local network
3. Use the WLAN adapter software in your desktop PC or notebook to
perform a Site Survey. Make sure the desktop PC or notebook WLAN
adapter is set to Infrastructure mode.
4. Establish connection with the ASUS Pocket Wireless AP.
5. Configure the IP settings of the desktop PC or notebook to establish
connection to the local network.
6. Check your connection.
Use the Web Configuration utility only if you need to change the device
SSID or WEP encryption settings.
Replacing the Ethernet cable of desktop PCs or notebooks
Follow these instructions to replace your desktop PC or notebook cable
connection to an ADSL or cable modem with the ASUS Pocket Wireless AP.
1. Switch the device to AP mode using the mode switch. (Default SSID:
AP_xxxxxx)
2. Turn on the ASUS Pocket Wireless AP, then connect one end of the
RJ-45 cable to the Ethernet port of the device and the other end to the
Ethernet port of the ADSL or cable modem.
3. Use the WLAN adapter software in your desktop PC or notebook to
perform a Site Survey. Make sure the desktop PC or notebook WLAN
adapter is set to Infrastructure mode.
ASUS Pocket Wireless Access Point (WL-330)
Quick Start Guide
15