Sony HVR-S270E Operating Manual page 11

Adjusting the flange focal length
automatically
1 Set the CAMERA MODE switch F to
MANUAL.
2 Set the IRIS switch E to MAN.
3 Set the gain to 0dB with the gain switch H.
If you have not changed the gain switch
setting from the default, set the gain
switch H to L.
Make sure that the AGC switch is set to
OFF.
4 Set the shutter speed to automatic
adjustment mode (p. 35).
5 Fully open the aperture with the iris ring
I.
6 Place the flange focal length adjustment
test chart A about 2-3 meters (7-10
feet) away.
Adjust the lighting or the ND filter B
so that a subject is properly lighted.
7 Set the ZOOM switch J to SERVO.
8 Select [AUTO ADJUST] in [FLANGE
BACK] of (CAMERA SET) menu
(p. 74).
9 Select [YES] with the SEL/PUSH
EXEC dial G.
The flange focal length adjustment starts
and [EXECUTING] appears on the screen.
When the adjustment is completed,
[Completed.] appears on the screen.
If the adjustment fails, [Could not adjust.]
appears on the screen. Try the adjustment
again.
Adjusting the flange focal length
manually
1 Perform steps 1 through 4 of
"Adjusting the flange focal length
automatically."
2 Set the ZOOM switch J to MANUAL.
3 Select [MANU ADJUST] in [FLANGE
BACK] of (CAMERA SET) menu.
4 Select [YES] with the SEL/PUSH
EXEC dial G.
5 Turn the zoom ring D fully to the
telephoto side.
6 Turn the focus ring C until the subject
comes in focus, then press the SEL/
PUSH EXEC dial G.
7 Turn the zoom ring D fully to the wide
angle side.
8 Turn the focus ring C until the subject
comes in focus, then press the SEL/
PUSH EXEC dial G.
11
Continued ,