Advertisement
1. Check Connections.
2. Check high level input wiring (if applicable).
3. Make sure RCA connections are secure and not shorting.
4. Check power connections for 12 volts and ground.
NO SOUND: Check all signal connections. Check that the power indicator is on.
Check for the +12Vdc on the bat and rem wires. Check the gnd wire connection.
Bypass the PA-1
©
BLOWS FUSES: Check all connections to be sure all power wires do not touch
ground or each other. Re-check polarity of main power wires.
NOISE PROBLEMS: Be sure the metal sleeve on the RCA (phono) jack does
not touch the metal chassis of the vehicle, the chassis of the PA-1
chassis of any other component in your installation. Route signal cables away
from power wires, power connectors, speaker wires, engine alternator and
vehicle firewall. Make sure all amplifier(s) or head unit(s) are properly and
securely grounded.
To obtain modification, service or repair, please contact our ONLY Authorized
LINEAR POWER™ Product Service Center:
3 4 5 5 L A N E L L L A N E, P E A R L, M S 3 9 2 0 8 (6 0 1) 9 3 2 – 8 4 7 7
TROUBLESHOOTING
and check for signal output.
SERVICE OR REPAIR
T.I.P.S. INC.
3455 Lanell lane, Pearl, MS 39208
(601) 932-8477
E-mail:
ray@tipsinc.net
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
, or the
©
™
3
Advertisement
