Advertisement
8. Source 2 low level inputs, use either these or speaker level inputs described in
#9. Warning: Do not use "high power" output to this input as it will damage
both low level source inputs of the PA-1
.
©
9. Speaker level inputs for Source 2 (for wiring see diagram). Do not use Source
2 low level inputs if using this input.
10. Black Wire-Chassis ground, should be connected to source ground to avoid
noise. (Connect to where your radio, tape, or CD is grounded.)
11. Red Wire- Should be connected to remote turn on lead from either source or
switched wire with ignition, or to constant 12 Volt source (battery). Note: If you
use a constant 12V power source you must remember to turn off PA-1
when
©
you turn off your vehicle.
12. Low level output to amplifier.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
2
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
