CASUALPLAY sono Instructions Manual page 12

INSTALLING THE SONO IN THE CAR
• Set the handle to position A - fig.5.
• Fasten the buckle of the car seat belt and pass the abdominal strap through the two lower belt
guides (fig.15).
• Next, pass the chest strap through the upper belt guide on the same side as the retractor
(fig.16).
WARNING: Adjust the tightening of the seat belt every time you change the position of the
backrest.
• Lastly, tighten the seat belt by pulling the chest strap (fig.17).
REMOVING THE UPHOLSTERY
• Remove the foot cover, unfastening the hooks on the sides of the frame and velcro front (fig.18).
Remove the hood (fig.19).
•
• Unfasten the harness buckle (fig.20).
• Remove the chest protector pads and the reduction cushion. Pass the harness straps through the
vents in the upholstery (fig.21).
• Take the upholstery off, starting with the front part.
UNISYSTEM
This exclusive fastening system means that the Sono can be used on the following pushchairs:
Avant, Kudu, Kudu Four, S4, S-Twinner.
For all of them, the installation procedure is the following:
• Put the parking brake on.
• Place the Sono on the pushchair, facing backwards.
• Line the Sono Unisystem fasteners up with the slots (fig.22).
• Press downwards until it clicks into place and a green signal appears in each of the windows on
the sides of the fasteners (fig.23).
• To remove it, press and then release the red button on both fasteners (window displays red signal)
and pull upwards to release it from the chassis of the pushchair (fig.24).
12
español