Hoover HVBF 5182WWK Instruction Book page 21

Attentions: Make sure that the water tank is empty before moving it.
1. The water valve components are non-detachable;
II. Cleaning
1. To disassemble the water tank, water tank cover, sealing ring and water valve;
2. Use cold or warm water to cleaning the components of water dispenser.
3. Wipe it with dry cloth.
Attentions:
1. If the cleaning solution is used for cleaning water dispenser, then it is suggested that,
before the water taking and drinking, the water shall be drained to the amount of 5-6 cups
after the water tank is installed back, so as to avoid the residue cleaning solution.
III. Installation
1. Installation of water valve components
The guiding boss on the water valve components shall be in alignment with the guiding slot
on the base, and press it down in the direction of in the direction of 45°of oblique downward
by hands with strength, until you may hear the sound of "lick".
Guiding boss
Guiding slot
2. Installation of water tank sealing ring
To install the sealing ring on the bottom of water tank by hand, make sure that it is properly
installed, and the wrinkling and oblique installation and so on
shall be avoided.
16