Table of Contents
Advertisement
Door instal l guidel ines about swapping l ef t&right
Attachment
1. Components that could be transferred from one side to the other directly after disassembling are listed
below:
top door top endcap coverslip (2pcs)
top cover buckle (1pc)
hinge shaft sleeve (1 or 2pcs)
screws of top hinge (3 pcs)
middle hinge assembly (1 pc)
screws of middle hinge (2 pcs)
insert nail (2 pcs)
screw cap (2 pcs)
door stopper (1 pc)
bottom hinge assembly (1 pc)
screws of lower hinge (3pcs)
2. The component that could be swapped over from one side to the other only after reconstruction is listed
below
top hinge assembly
3. Components that could be swapped over from one side to the other in pairs are listed below:
adjustable foot with
internal thread
adjustable foot with bolt (fixed at the bottom)
4. Components that could not be reused temporarily are listed below:
left block on top door
right block on top door
Ensure the Appliance is unplugged and empty
Adjust the two leveling feet to their highest position
We recommend you have someone to assist you
NOTE
To take the door off it is necessary to tilt the Appliance backward
You should rest the Appliance on something solid e.g.a chair just below the top panel
Do not lay the Appliance completely flat as this may damage the coolant system
10 Set the top door right position,fix the top-hinge and the cover.
11 Install the four screw caps and two catches to
corresponding position.
Ensure the Appliance is unplugged and empty.
Adjust the two leveling feet to their highest position.
We recommend you have someone to assist you.
12 replace the leveler to the other side and adjust it to make
sure the cabinet level
(used with the lower hinge)
11
Advertisement
Table of Contents
