Bushnell Pro X7 Jolt 201400 Manual page 14

TROUBLE SHOOTING TABLE
If unit does not turn on VDT™ does not illuminate:
• Depress power button.
• Check and if necessary, replace battery. If unit does not respond to key presses, replace the battery with a good
quality CR123 3-volt Lithium battery.
• Ensure the display is on the brightest setting while in sunlight. While pressing Power Button, cover the objective
lenses to determine if the display is on. See the display brightness setting instructions on Page 10.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality CR123 3-volt Lithium battery.
If target range cannot be obtained:
• Make sure VDT™ is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target)
that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
NOTE: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using the VDT™'s reticle, depress
the power button and hold until new range reading is displayed. Specifications, instructions, and the operation of these products are subject to change
without notice.
14