Chevrolet 2006 Monte Carlo Getting To Know Manual page 12

Getting to Know Your Monte Carlo
12
Preset Stations (Base radio)
To Preset up to 18 Stations:
1. Turn on the radio.
2. Press BAND to select FM1, FM2
or AM.
3. Tune to the desired radio station.
4. Press and hold one of the six number-
ed pushbuttons until a beep sounds.
5. Repeat steps 2 through 4 for each
pushbutton.
Favorite Stations (Uplevel radios,
if equipped)
FAV (Favorite) (if equipped): Press this
button to go through up to six pages of
any combination (AM, FM or XM, if
equipped) of favorite radio stations. On
each page, up to six stations are avail-
able by using the six pushbuttons below
the radio station frequency labels on the
radio display.
To Set Up the Number of Favorite
Station Pages:
1. Turn on the radio.
2. Press the MENU button to display the
radio setup menu.
3. Press the pushbutton located below
the FAV 1–6 label on the radio display.
4. Select the desired number of favorite
station pages.
5. Press the FAV button. You may now
begin storing your favorite stations for
the chosen number of pages.
To Store Favorite Stations:
1. Turn on the radio.
2. Tune to the desired radio station.
3. Press the FAV button to display the
page where the station is to be stored.
4. Press and hold one of the six push-
buttons until a beep sounds.
5. Repeat steps 2 through 4 for each
pushbutton on each page.
Setting the Speed Compensated
Volume (if equipped)
With Speed Compensated Volume, the
radio automatically adjusts the volume
to compensate for road noise as vehicle
speed changes.
To Set Speed Compensated Volume:
1. Set the radio volume to the desired
level.
2. Press the MENU button to display the
radio setup menu.
3. Press the pushbutton below the auto
volume label on the radio display.
4. Press the pushbutton under the
desired setting (Off, Low, Medium or
High) to select the level of compensa-
tion. For the Premium Sound System,
the settings are On and Off.
5. The compensation will be set once the
display times out after 10 seconds.
Setting the Time
To Set the Time (without Date
Display):
1. Press the (Clock) button until the
hour numbers begin flashing on the
radio display. Press the button again
to adjust the minute numbers.
2. With either the hour or minute num-
bers flashing, use the Tune knob to
select the time.
3. Press the Clock button again to set
the currently displayed time.
To Set the Time (with Date Display,
if equipped):
1. Press the (Clock) button. Or, if