Connecting For 10-Mbps Ethernet; Software Installation - D-Link DFE-530TX User Manual

Hide thumbs Also See for DFE-530TX:

Table of Contents

DFE-530TX 10/100Mbps Ethernet Adapter for PCI Bus

Connecting for 10-Mbps Ethernet

Category 3, Category 4, and Category 5 UTP cable, as well

as EIA/TIA-568 100-ohm STP cable, all qualify under

Ethernet cabling rules. The maximum cable run between

the DFE-530TX and the supporting hub is 100 meters. The

cable must be straight (not a crossover cable) with RJ-45

connector at each end. Make the network connection by

plugging one end of the cable into the RJ-45 jack of the

DFE-530TX, and the other end into a port of the supporting

hub.

On account of the great variety of network environments for

which the DFE-530TX may be used, and revisions of those

network systems, the instructions for software installation

are given as README files on the DFE-530TX Software

Diskette. Review the root directory README for overview

information, and for full installation details, see the

README and referenced instruction files in the sub-

directory appropriate to your network operating system.

Installation

Table of Contents