Auto Drawer Gear Removal/Installation; Rack Gear/Oil Damper Removal/Installation; Oil Damper Information - Sharp KB-6524PS Service Manual

Hide thumbs Also See for KB-6524PS:

Operation manual (24 pages)

Installation tips (2 pages)

Installation tips (2 pages)

Table Of Contents

Table of Contents

(This procedure can be performed without removing the outercase)

. If you are just replacing the Auto drawer Gear, it will not be necessary to follow the "Microwave Drawer Disassembly"

as previously stated.

2. Turn the Drawer up on its back and knockout the Auto Drawer Gear hole cover (Fig. G-1).

3. Unhook wiring connector to Auto Drawer Gear motor.

5. Remove the (4) screws holding the auto drawer gear to the bottom cavity angle (Fig. G-2).

6. Disengage (pull) Auto Drawer Gear motor from rack gear.

7. The Auto Drawer Gear motor is now free.

Installation:

. Proceed in reverse to reinstall the Auto Drawer Gear motor taking care that the gear teeth are set into the cavity angle

correctly before tightening screws .

2. After Auto drawer Gear is reinstalled, insert the hole cover in reverse order so that it can be secured with a XOTS740P2000

common screw.

Fig. G-1

. Follow the Microwave Drawer disassembly as previously stated.

2. Open the drawer and keep it open.

3. To discharge the high voltage capacitor, wait for 60 seconds.

4. Remove the Microwave Drawer by following steps under "DRAWER SUPPORT ANGLE REMOVAL".

5. Remove the (3) screws holding the Rack Gear to the bottom slide rail (Fig. G-3).

6. With the bottom slide rail off, locate tab holding Oil Damper and remove, then replace with new one (Fig. G-4).

7. Proceed in reverse to reinstall the new Rack Gear. and/or Oil Damper.