Connecting To Gprs Network - Metrologic OptimusPDA SP5700 Series User Manual

6. Troubleshooting
The following table lists common issues that may occur along with possible solutions. Please
contact Metrologic if an issue occurs which is not covered here
.
Problem
Low-Battery
Problem
OS is not
button's rubber
loading
Battery malfunction
PDA turns itself OptimusPDA is inactive
off (Sleep Mode)
Battery failure
Device
Battery does
from cradle while battery
not charge
was charging
I/O
clean
Characters on PDA is not powered on
display are
Battery is not charged
invisible
IP error
Communication
failure with
IrDA printer IP crash
The stylus pen Shortcut icons do not
does not tap activate the
correctly corresponding function
Too many files stored in
memory module
A message
Memory allocation is too
appears stating
low
that your PDAs
memory is full
Too many applications
are installed on your
OptimusPDA
Copyright © 2007
Metrologic, Inc.
OptimusPDA SP5700 Series User Manual
Cause
with Reset
was removed
connector is not
6 1
Solution
Charge or replace the battery.
If reset rubber can be pressed with your finger,
then cut the tip of the rubber.
Remove the battery from the PDA and do a soft
reset. Then re-insert the battery into the PDA.
PDA turns off after a period of inactivity. The
period can be set under Settings-Power. Press
the power button to turn the PDA on and return
it to its previous status (prior to going in to sleep
mode).
Replace battery. If your terminal still does not
operate, try a hard reset.
Re-Insert your PDA into the cradle. Ensure that
the PDA is turned off or in a sleep mode while
being charged.
Clean up the I/O connector.
Press the Power button.
Charge the battery.
Fix the static IP address.
Check whether more than two users work under
the same static IP address.
Select Start → Settings and double tap on
Stylus. Then recalibrate the stylus.
Delete unused files or transfer data to your PC.
Adjust the memory allocation. Tap Start
Settings → Control Panel, then double tap the
System tab. Select Memory and adjust the
slider.
If you have installed new applications on your
PDA, remove unused applications to extend
memory capacity. Tap Start
Control Panel, and double tap Remove
Programs. Then select unused programs and
tap on Remove button.
Version 2.0
→
Settings →
→
29 March 2007