Setup; Temperature Units - ACU-RITE 02042 Instruction Manual

SETUP

Install or Replace Battery
AcuRite recommends high quality
alkaline batteries for the best
product performance. Heavy duty
or rechargeable batteries are not
recommended.
1
Slide the battery compartment
cover open and install 1 fresh
"AAA" battery. Follow the polarity
(+/-) diagram in the battery
compartment.
2
Replace battery cover.
Select Temperature Units
To select between degrees Fahrenheit (°F) or Celsius (°C) temperature units,
slide the "°F/ °C" switch, located inside the battery compartment on the back
of the display.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
OPERATION
Display Modes
MANUAL: By default, the unit is in MANUAL mode. During Manual Mode,
press and release the "SELECT" button, located on the front of the display, to
manually cycle through readings and records.
AUTO CYCLE: In AUTO-CYCLE mode, the display will automatically cycle
through current readings for INDOOR (display) and OUTDOOR (sensor)
temperature and humidity. Each reading will be displayed for 5 seconds.
Press and HOLD the "SELECT" button on the front of the display for 5 seconds
to enter AUTO-CYCLE mode. The
To exit AUTO-CYCLE mode, press and HOLD the "SELECT" button for 5
seconds. The icon will disappear from the display.
1
icon will appear on the display.
4
2