Table of Contents
Advertisement
XT front panel Power button is disabled
so that on/off is determined solely by the
triggering preamp or controller.
Man Position
When the Man Auto switch is in its Man
(manual) position, the auto turn on
function is disabled and the XT must be
turned on and off manually with the
Power button on its front panel.
AUTO Position
When the Man Auto switch is set to its
Auto position, the XT is turned on and off
with either an external dc or ac voltage of
3.3V to 30V from your controller or
preamplifier. When external voltage
ceases the XT will turn off immediately.
The Auto switch position disables the
front panel Power button.
IN (3-30V AC/DC)
The XT 3-30V AC/DC input uses a 2.5mm
dc jack. To trigger the XT, plug one end of
the cord into this jack and the other end
into the source component's trigger
output. Some components may use a
3.5mm trigger output jack, so you may
have to use a 3.5mm jack to 2.5mm plug
adaptor.
OUT (12VDC)
The 12Vdc trigger loop jack lets you
"daisy-chain" the incoming trigger voltage
to an additional XT or other component.
5
Advertisement
Table of Contents
