Set The Controls To Automatic Mode Operation; Turn Refrigerator Off; Remove The Refrigerator - Norcold N3000 series Installation And Owner's Manual

Set the Controls to Automatic Mode Operation

Push the source button several times, as illustrated. Push until the desired source
(A, 'auto') is selected and displayed.
If the engine is running, DC mode will be selected and displayed.
If the engine is not running, and 120 volts AC is available to the refrigerator, AC mode will be
selected and displayed.
If the engine is not running, and 120 volts AC is NOT available to the refrigerator, gas mode
will be selected and displayed.
If the gas does not ignite after several attempts, refer to the "Troubleshooting" section of this manual.
If the 'auto' function on the refrigerator is selected, but no source is available, a light in the on/off switch blinks red.

Turn Refrigerator Off

Before defrosting the refrigerator or storing your vehicle, turn the refrigerator off. Push the
on/off switch, as illustrated, and hold it for 2 seconds to turn the refrigerator off. All lights will
go out.
If storing the vehicle for an extended period of time, make sure to disconnect
NOTICE
the fan at the rear of the refrigerator, as explained in section entitled
"Refrigerator Storage".

Remove the Refrigerator

Your dealer or Norcold authorized service center must do this procedure.
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on the
!
CAUTION
refrigerator, be careful and wear cut resistant gloves.
1. Close the valve at the propane gas tank(s).
To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the gas supply line
!
WARNING connections.
2. Open the lower intake vent , and remove the refrigerator AC power cord from the receptacle.
3. Remove the DC wiring from the refrigerator:
- Remove the DC fuse or remove the DC wiring from the battery or the converter.
- Remove the refrigerator DC power cord from the vehicle wiring plug.
4. Remove the gas supply line from the bulkhead fi tting of the refrigerator.
5. Remove the white plastic plugs from the sides of the refrigerator interior.
6. Remove the screws from the sides of the refrigerator interior.
7. Remove the refrigerator from the opening.
Installation and Owner's Manual 28
Art02367
Art02353