Sending A Fax - CONCORD FaxLync User Manual

W
hen sending a fax from your FaxLync-enabled fax machine, or MFP, your call
does not transmit over telephone lines. The fax call is passed on to the FaxLync
device connected to your fax device. FaxLync then connects to Concord Fax
Web Services Platform via HTTPS (using port 443). The fax job is then queued for delivery on
the Concord fax delivery platform. In the event the initial delivery attempt fails, Concord will
reattempt delivery up to 4 times, every 5 minutes, until the fax is delivered successfully or the
maximum retry limit has been reached.
Upon confirmation of delivery, or failure, a notification will be sent to the
FaxLync device reflecting the final delivery status. This notification will print
from the fax machine, or MFP, on which the original fax job was sent.
The reports printed from your fax machine/MFP only reflect the initial call
made to the local FaxLync device ATA, not the final delivery status. Therefore,
it is important to use the FaxLync notifications for confirmation of delivery.
To Send a Fax via FaxLync
1. Prepare your document, and load the fax into your fax machine as you
would normally.
2. You will not need to first dial to get an outside line! (if you had to do
so previously): the fax machine will first call the FaxLync device before
routing to the Concord platform via your internet connection.
FaxLync User Guide | concordfax.com | sales@concordfax.com | +1 (206)-441-3346

SENDING A FAX

8