Table of Contents
Advertisement
Section 1 – INTRODUCTION
The Model 5306 StripIR
requires a clean, responsive, non-contact heat source.
Typical applications for the Model 5306 include:
Drying paint
Curing adhesive
Drying ink
Forming plastic
Stress relieving metal
Heat treating
The Model 5306 includes the following major components:
Heater Module – The heater consists of a specular aluminum reflector that directs the
infrared energy generated by one ceramic end-seal 'T-3 style' quartz halogen lamp
factory-installed in the heater. Heated lengths of 2.56, 5, 11, 16, 25, and 38 inches (65,
127, 279, 406, 635, and 965 mm) are offered for the Model 5306. Additional lamps can
be ordered separately from the heater.
Water Cooling – Adequate cooling water is required during operation of the Model
5306. Flexible tubing and plumbing fittings are supplied with each heater for easy
installation. Required cooling water flow rates are listed in Specifications.
106837-001 Rev. 1
®
Infrared line heater is designed for use in any application that
1-1
StripIR
Advertisement
Table of Contents
