McIntosh XR50 Owner's Manual page 11

Spade Lug or Wire Connections:
11. Referring to the illustration on the next page, con-
nect the Loudspeaker hookup cables to the XR50
Negative (-) Input Terminal and Positive (+) Input
Terminal. Insert the spade lug connector or pre-
pared
section
of the
cable
end
Figure 15
into
the
terminal side access hole, and tighten the termi-
nal cap until the cable is firmly clamped into the
terminals so the lugs or wire cannot slip out. Refer
to figures 15 and 16.
Note: It is important to maintain the correct polar-
ity at both ends of the Loudspeaker cables.
11. Connect the other end of Loudspeaker cables com-
ing from the XR50 Negative (-) Input Terminal to
the Left Channel COM (-) Output Terminal of the
Amplifier.
12. In a similar manner, connect the Loudspeaker
cables coming from the XR50 Positive (+) Input
Terminal to the Left Channel 8 ohm (+) Output
Terminal of the Amplifier.
13. Connect the second XR50 Loudspeaker to the Am-
plifier in a similar manner.
14. Connect the second XR50 Loudspeaker in a
similar manner to the Amplifier Right Channel
Terminals.
Figure 16
Power Amplifier
XR50 Right Channel
6.6
XR50 Left Channel
How to Connect
11