Rudder Ready - Wilderness Systems Commander Series Instruction Manual

ANGLER EDITION
11. Take running end of anchor rode (line) and clip
through carabiner on anchor trolley line.
12. Secure end of anchor rode onto horn cleat next
to Captain's Seat.
13. Unwrap anchor trolley line from SlideTrax fitting
so that you can position angle and location
anchor will run from its' set to your boat. This is
achieved by guiding anchor line where it runs
through carabiner to move forward or back
alongside of hull. Once position is determined
re-wrap trolley line down around SlideTrax fitting
next to seat to lock in position.
14. The round ring to which the carabiner is
attached is designed to anchor a setting pole,
often used as an anchor in shallow, sandy
bottoms. Simply push your setting pole through
the ring to hold your boat in place.
8
RUDDER – READY COMMANDERS
If your Commander was not ordered with factory
installed rudder, Wilderness Systems has made it
easy to change your mind. All Commanders are
shipped rudder-ready. The tubes running
underneath the deck that contain and guide the
rudder cables from stern to footpedals are factory
installed as are inserts to mount a rudder bracket to
stern.
To install a rudder on your Commander, you will
need to order a BTS Rudder Ready Kit (#8025416)
which includes all necessary components to install
a rudder. Minor drilling of deck is required for
installation.
(Visit www.HarmonyGear.com)
RUDDER – READY COMMANDERS