Table of Contents
Advertisement
6
A. ASSEMBLY OF
STEP 1 SECURING THE CAST BURNER TO THE BASE
— Place base (1) upside down on an even surface. The wider ring
of the base should be facing down¬ward.
— Locate the burner mount bar stretching across the narrower
ring of the base.
— Remove the nut from the bottom of the cast burner (2).
— From the bottom side of the burner mount bar, place the cast
burner into the groove in the center of the bar. The screw on
the cast burner should fit through the hole in the center of the
mount bar. The cast burner should be positioned towards the
side of the base with the cutout section.
— The Heat Shield (4) must be installed before placing the nut on
the burner post and tightened.
— Fasten the cast burner screw securely to the burner mount bar
with the nut.
NOTE: The serrated washer that is attached to the nut, should make contact with the heat shield.
STEP 2 LEG ASSEMBLY
— Locate 3 x legs (6)
— Join each of the legs to the base ring, so that the two
holes of each leg are aligned with each set of two holes on
the base. When in position, the legs should be projecting
outward from the center of the base.
— Securely fasten each leg to the base with two M6x10
screws and M6 nuts per leg. The screws should be inserted
from the outside towards the center of the ring.
THE
CRAB COOKER
Burner Mount Bar
4
6
1
2
6
6
Advertisement
Table of Contents
