Step 2: Initial Setup; Accueq Room Calibration - Onkyo TX-RZ900 Basic Manual

Step 2:
Initial Setup
"Initial Setup" automatically starts on the television when
you first turn the unit on.
Settings proceed in the following order:

1 AccuEQ Room Calibration

･ Automatic calibration for optimum speaker settings
2 Source Connection
･ Checking that each input source is connected correctly
･ HDMI link function settings
3 Remote Mode Setup
･ Settings required to operate other AV Components with
the Remote Controller
4 Network Connection
･ Checking network connections
･ Wi-Fi settings
＊ Firmware update notification: If the unit is connected via LAN and there
is firmware update available, the "Firmware Update Available" message will
appear. To execute updating, select "Update Now" with the cursor buttons of
the remote controller and press ENTER.
When "Completed!" appears, press zON/STANDBY on the main unit to
turn the unit into standby mode. Then updating will be completed. (The unit
automatically turns itself into standby mode after about 3 minutes even if
you don't press zON/STANDBY, and updating will be complete.)
En-12
Before Start
Setup is performed as a series of responses to questions
asked by the unit. Select the item with the cursors of
the remote controller and press ENTER to confirm your
selection. To return to the previous screen, press RETURN.
Initial Setup
･ Switch the input on the TV to that assigned to the unit.
Language Select
English
Deutsch
Français
Español
Italiano
Nederlands
Svenska
SETUP Exit
Select the language first. Next, a summary of the initial
settings is displayed. Select "Yes" in this screen and press
ENTER on the remote controller.
Re-doing initial setup: If you terminate the
procedure on the way or change the setting made in
the initial setup and want to call up the setup wizard
again, press RCV and then SETUP on the remote
controller, select "8. Miscellaneous" - "Initial Setup",
and press ENTER.
Initial Setup
Welcome to initial setup.
Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
1st Step : AccuEQ Room Calibration
2nd Step : Source Connection
3rd Step : Remote Mode Setup
4th Step : Network Connection
Yes
No
SETUP Exit
1
AccuEQ Room Calibration
The test tone coming from each speaker will be measured
to enable setting of the number of speakers, volume
level, each speaker's optimum crossover frequencies,
and distance from the primary listening position, and also
enable correction of distortion caused by the room acoustic
environment.
･ You cannot return to the previous screen during speaker
setup, even if you press RETURN.
1. Place the speaker setup microphone.
Initial Setup
AccuEQ Room Calibration
This step you can automatically calibrate
your room to get correct surround sound.
Would you like to calibrate your room now
or later?
Do it Now
Do it Later
When the above screen is displayed, before starting
the procedure, place the supplied speaker setup
microphone at the measurement position ★ by referring
to the following figure.
Listening area
Measurement position
with microphone
SETUP Exit