Table of Contents
Advertisement
8
9
10
6
•
Slide bagger handle (13) down through bagger cover
and frame holes.
•
Reinstall clevis pin (11) through hole at bottom of bag-
ger handle (13) and slide retainer spring (12) into hole
at the end of the clevis pin (11) until it locks into place.
13
TO INSTALL BAGGER SUPPORT ASSEMBLY
(See Figs 9 - 11)
•
Using two carriage bolts (1) and two nuts (2), secure the
left hand mid bracket (3) to the left hand front bracket
(4) as shown. Mid brackets should be on the outside
of the front brackets. Repeat on opposite side.
NOTE: Nominal position (5) is when edges of brackets
are aligned as shown.
1
3
ASSEMBLY
7
Fig. 7
12
Fig. 8
5
4
2
Fig. 9
•
Connect the strut (6) to the left and right mid brackets
using two carriage bolts (7) on each side. Do not install
nuts in this step.
•
Install the right bagger pivot (8) using one screw (9)
and nuts (10) as shown. Repeat on opposite side.
13
10
11
TO ADJUST BAGGER (See Figs 12 - 14)
HORIZONTAL ADJUSTMENT
The tractor comes from the factory with the bagger assem-
bly preset in a fixed position. If necessary, this position
can be adjusted to maintain a consistent gap (A) between
the fender and the bagger assembly top. An ideal gap is
approximately 0.25" (6 mm).
•
Insert 1/2" (13mm) wrench under bagger assembly top
(1). Do NOT remove; ONLY loosen adjustment bolt
(2). Repeat on opposite side.
8
6
7
7
Fig. 10
8
9
Fig. 11
1
2
Fig. 12
1
Hide quick links:
Advertisement
Table of Contents
